F1E1 is described one way for built-in JennAir microwaves and another for over-the-range ones; the breaker reset is identical.
Model compatibility: JennAir reuses codes across series and model years, so F1E1 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
On JennAir's built-in microwave page, F1E1 means a possible problem with the Oven Appliance Manager Control or its wiring.
Start with the breaker reset
Switch the circuit breaker off and keep it off for one minute.
Switch it on again.
Give the microwave one minute and see whether F1E1 shows up again.
Verify operation.
JennAir gives this identical procedure on both of its microwave pages.
Where JennAir’s pages part ways
The manufacturer does not describe F1E1 the same way everywhere, so the type of microwave you own matters.
Built-in: the Oven Appliance Manager Control, or the associated wiring, may be at fault.
Over-the-range: JennAir adds that the oven could not execute the function, and points to the Relay Control Board or the associated wiring.
The built-in text is the basis. The over-the-range text is included too because JennAir files it under F1E1, and nothing on either page says the two named parts are one and the same.
Which description applies to you
A microwave set into a cabinet or wall takes the built-in wording. One mounted over a range takes the over-the-range wording.
About the appliance manager
Think of an appliance manager as a circuit board directing the various things a microwave does. The built-in page never says what the unit failed to do and offers no cause.
When the code comes back
JennAir’s over-the-range page says a qualified technician may be needed. The built-in page stops at the reset. Say which kind of microwave you have when describing the job, so the matching part name is used.
Codes worth comparing
F1E3 and F6E7: both name the Microwave Appliance Manager.
F6E6: the same manager control, just listed under a second number.
F6E0: a built-in unit gets a temperature sensor or the oven manager here, while an over-the-range unit gets the Appliance Control Board.
JennAir microwave control board service in Los Angeles
Our Los Angeles line for JennAir microwave work is (310) 622-9465. Tell us whether the unit is built in or over the range, and what F1E1 looked like after the breaker was cycled. The microwave repair page has more on what we handle.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your JennAir appliance?
Book a specialist visit for a clear estimate and approval before any repair.
