JennAir Refrigerator CL Error Code

When CL appears on a JennAir beverage center, the unit is reporting that its internal temperature has dropped too low. On JennAir’s help page the message is titled “CL or LO”, so the two are handled together.

Check these before anything else

The manufacturer’s page names a few everyday situations that can lower the temperature or keep it from settling. Go through them in turn:

• The door may not be fully closed, or it may have stood open for a long time.
• The cabinet may have just been restocked. A large amount of warm or room-temperature product can lower the temperature reading.
• Power may have gone out recently. After an outage the unit needs time to stabilize.

If one of these applies, give the beverage center time first. JennAir does not point to a faulty part for CL.

Power cycle, as JennAir describes it

1. Cut power for one minute. Use the circuit breaker, or pull the plug of the beverage center.
2. Restore power.
3. Keep an eye on the display for one minute and see whether CL returns.
4. Verify that the beverage center is operating.

If CL does not go away

A CL that survives stabilizing time and a power cycle goes beyond what the owner page covers. The page gives no further steps and no cause to chase, so the unit should be looked at by a technician.

Codes worth comparing

• LO: printed on the very same beverage center help entry
• E1, E2 and HI: undercounter codes where a reset is the only advice

JennAir beverage center repair in Los Angeles

For a CL that keeps coming back, reach the Los Angeles line at (310) 622-9465. It helps to say whether the door was shut, whether new items had just gone in, and whether you had already cycled the power. The refrigerator repair page has the details.

Source: JennAir Product Help, Beverage Center error codes