JennAir Range and Wall Oven F7E2, FBE1, FBE2, FEE8 and LO Codes

These five labels get very brief treatment on JennAir’s range and wall oven pages. Four are fault codes without a stated cause, and LO is not a fault on the range page at all.

LO first

A display of “Lo” or “Pre” after the oven is turned on simply says the oven temperature is low, under 170 degrees F, or that the oven is preheating. No reset is needed. On some models the display switches to the actual temperature at 170 degrees F and then climbs in steps of 5 degrees, and a tone sounds once the set temperature is reached.

The four fault codes

• F7E2: reset and no cause, per the wall oven page.
• FBE1: reset and no cause, per the range page.
• FBE2: reset and no cause, per the range page.
• FEE8: reset and no cause, per the range page.

The manufacturer’s instruction for each is to power down at the breaker or breakers for one minute, power back up, then monitor the oven for a minute so the code stays away, and verify operation. As no part is named and no cause is given, there is nothing for an owner to inspect.

After the reset

JennAir ends its guidance with the reset. When F7E2, FBE1, FBE2 or FEE8 returns, service is the reason to call.

See also

• F7E3: the following code, naming the water filter on wall ovens.
• F6E0: another control-side code that comes with a reset.

Oven fault service in Los Angeles

Dial (310) 622-9465 with the exact code and the appliance type if a reset leaves it showing.

Source: JennAir Product Help, Ranges; JennAir Product Help, Wall Ovens