Published September 2, 2026Updated October 17, 2026
Content status:
Verified
Error codeF9E2
ApplianceDishwasher
Quick answer
F9E2 on a JennAir dishwasher is a drain motor error. Check the drain path first, then cycle power.
Model compatibility: JennAir reuses codes across series and model years, so F9E2 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
F9E2 is listed by JennAir as a drain motor error.
Although JennAir classes F9E2 as a drain motor error, the advice opens with the drain path, not the motor.
The five points
New installation: confirm the garbage disposer knockout plug was taken out.
Look over the disposer and the drain for clogs.
If the drain hose is kinked, straighten it. JennAir states that a kinked or clogged hose can lead to poor drainage or none.
Confirm the hose installation: correct routing, correct side, inside the frame (new installations).
Cycle the power. When the error comes back, schedule service.
Meaning of a power cycle
Leave the dishwasher without power for 30 seconds. A corded unit is unplugged and plugged in again; a hard-wired one has its breaker turned off and on at the panel.
Motor name, blockage steps
The code title blames the motor, yet most steps deal with blockages and installation. The source never ties these together nor says which is typical. So the order is: eliminate the drain path, reset, then book service. Leave the pump area assembled.
New-installation items
The knockout plug and hose routing steps both refer to new installations. An older dishwasher may not need them, but looking over the hose for kinks remains on JennAir’s list regardless.
Similar drain pages
F9E1 is the long drain code, with extra filter, air gap and suds checks.
If F9E2 returns, ring (310) 622-9465. Mention whether the dishwasher is new and whether it connects to a disposer. See also the dishwasher repair page.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your JennAir appliance?
Book a specialist visit for a clear estimate and approval before any repair.
