JennAir Range and Wall Oven FCE1 Error Code

This is a message about connectivity, not about cooking. When FCE1 appears, JennAir says the appliance could not reach the router, with these possible reasons: the connection timed out, the signal is weak, the router has failed, the appliance’s Wi-Fi module is faulty, or the wiring to that module is.

Network checks first

Most of JennAir’s list deals with the home network rather than the oven.

1. Reset the wireless router.
2. See whether another Wi-Fi device, such as a smartphone or tablet, works properly.
3. Take that device next to the appliance and try it there.
4. If it works, unplug the router for 2 minutes and plug it back in, and then do the same for the appliance, also for 2 minutes.

Weak signal at the appliance

Without full bars at the appliance, JennAir gives three options: place the router somewhere else in the home, add a compatible signal extender, or talk to the internet service provider.

The appliance breaker

The standard routine is listed too. Switch the appliance’s breaker off for a minute, on again, and monitor it for a minute for the code. Finish by verifying that the appliance operates.

Limits of the entry

The causes are listed without any ranking. Only the router steps are things an owner can do. When the network is fine and FCE1 stays, the Wi-Fi module and its wiring, which are on JennAir’s list, are for a technician to inspect.

Other Wi-Fi codes

• FCE2 and FCE3 are written with identical text.
• FCE7 is the message about not connecting to your router.
• FCE8 concerns registration, not signal.

Connected oven service in Los Angeles

If the Wi-Fi module itself may be at fault, call JennAir oven service in Los Angeles at (310) 622-9465. List the router steps you already finished.

Source: JennAir Product Help – Wall Ovens; JennAir Product Help – Ranges; JennAir Product Help – Over-the-Range Microwave